Installation Process

The synthetic turf is installed over a sub-base and base in concrete or asphalt 5cm + 2cm thick with the necessary flatness and with a slope around 0.8-1% between the middle and the side-base lines. A drainage collector should be installed behind the base lines (if necessary)

Installation of shock-pad + synthetic grass

The shock-pad rolls should be unrolled on the field in a cross direction and jointed together with a fibreglass net and special glue. All the area must be covered by a tnt geotextile blocking all the surface with nails and/or glue.

The synthetic grass rolls should be unrolled on the field in a cross direction. The edges are then adjusted by trimming 2-3cm on both sides in order to obtain perfectly straight rolls.
The Roll seaming tape used will be in 100% pes non woven geotextile, the glue used will be two component p.u. glue, at a quantity per linear meter of +/- 400 gr. The weather and the glueing area should be dry.

The lines are traced with ropes, they being 8-10cm wide (yellow or white). Then, the green turf is cut along these ropes using a rigid ruler and these pieces removed. Saving time and obtaining a better linear result, we use a double bladed knife tool with the distance between the blades of 10cm. Then the prefabricated lines are inserted seaming them to the green turf using the same tape and glue as for seaming rolls.